Suspension?

[bruiser]

whats everyone runnig?
i have the DJM 2/3 but it measured to about 3/4 i like it
heres a pic

Before:
http://i60.photobucket.com/albums/h5/clay89ton/dangerranger005.jpg

After:
http://i60.photobucket.com/albums/h5/clay89ton/l_ce937685c07a557771be6eeafa46de82.jpg

[taknotes]

right now:expo axle, 2" djm coils
soon: upper/lower djm control arms in addition

[bruiser]

nice i need a expo rear end badddd!

[D94R]

I have an Ibeam Ranger. Had it as low as 6/8 for a while. Its now sitting somwhere around 3/5. Specs are in sig I think.

[fordnut71]

2/3
i have a fliped shackle with the over load spring removed an 1full coil removed in the front planing on a 3"drop beam an a fliped rear soon.

[radrangerXLT]

4/6 , DJM upper & lower arms, 2" drop coils up front and flip kit & 1" block in the rear. Handles like a dream!

[bruiser]

thats the next step i take
tubular control arms my tire rub like a B!!!!!!!

[turboranger_quest]

Belltech 2/3. Coils up front. Leafs out back. Belltech sway bars. It's slow but it handles nicely!

[96lowslow]

stock splash springs up front with belltech I-beams, djm rear flip kit boxed and welded on rear-end, belltech shocks all around and belltech front sway bar( cuz i broke the junky stocker) handles very well, corners flat , only prob is when you hit square bumps the truck does a little dance to the side , but thats what I-beam trucks do

[Riddle_Rob]

6/5 ATM. Was starting the other 2"~3" in the rear but my shackles are mangled.

Belltech beams, 3" Canuck Motorsports coils.
Explorer 8.8 rear end. THEN either hanger flip, belltech hangers (4" and i have them) or 3" blocks.

[Shane]

5.5up in front lift spindles and springs and about 3 up in the back after market leaf springs 9leaf

[splatranger95]

4 in drop dream beams and springs up front w a 5in axle flip in rear and I took out a leaf. Bigger sway bars Handles sweeeeeeeeeeet

[Shane]

i have no sway bars it gets old every left corner i lift a the out side tire off the ground

[TURBO Ranger]

Lower, not higher lol. I'm down around 2 inches out back and 1 up front. I relocated the front hangar on the back to go with the Expo 8.8 and the Mopar SS springs, and I put in 4.0L Expo front springs. Expo rear sway bar and biggest Ranger sway bar up front. It'll handle with my dad's Supercoupe, and out run it:D

[speedaddict]

Stock front, -3 in the rear.

[PvtRanger]

stock with a saggy front end so i put spring spacers in the front to level it....well sort of, it still sags in the front a bit but composite mono leafs in the rear...btw that suck

[michaelconklin]

6" drop in front ibeams & springs. 8.8 out back with 1" blocks