WTB - (2) two 90* mandrel bent IC pipes

[radrangerXLT]

To finish my IC piping I need one (1) uncut 90* , 2.5", aluminum, mandrel bent pipe. If anyone has one laying around please let me know. Very interested!

[mastersmith]

What Diameter I think I might have a couple laying around that are 2.5"

[radrangerXLT]

Yes, 2.5", I'm sorry i didn't specify earlier.

I fixed the original post.

[mastersmith]

I just checked and i do still have them. they are 5.5" radius and have beads rolled on either end. $20.00 shipped and their yours. I've also got a few silicon 90's I could give you if you need any of them to. and I have one section of straight 2.5 about 12" i think with beads on both ends. Let me know if your interested.

[radrangerXLT]

Just the two 90 bends would be great.

Pic's if you have them, please.

[mastersmith]

sorry for takin so long, I'll get some pics up tomorrow.

[mastersmith]

http://www.turborangerforums.com/imagehosting/7674c4fb4110c394.jpg
http://www.turborangerforums.com/imagehosting/7674c4fb41187b9e.jpg
sorry, not the best pics, but you get the idea

[radrangerXLT]

Sorry, those are too short for me to use.

I'm also only looking for 1 90* bend now.

*Original post edited