Oil Lines, Return

[PrerunningRanger]

Ok so when i get my motor out and all forged, what do i need to do to the motor as far as oil/turbo go while i have the motor out, do i need to tap the pan? or tap into the block? Or is there another way?

[nagelandy55]

Tap the block, if you search you'll find a thread about this. Jess has pics of his motor and where the hole needs to be drilled.

[PrerunningRanger]

Alright well ill look for that thread, i plan on pulling the motor as soon as i find a set of pistons and rods... so when i find a set ill make sure there forged, and do you think i need to get oversized? or just get a standard size and clean the block? And Also... dunno if you know what this might be but my truck right now when i start it, it runs fine.. but when i put it in first and start to drive it will run fine then it will get rough, but as soon as i give it a little gas it clears up, i think its an ignition problem, just wanted to know if anyone else had a prob, some what related to mine.. and Btw thanks for answering my questions